handheld Dynamic Mic with 16 FT Microphone Cables

handheld Dynamic Mic with 16 FT Microphone Cables

Product Code: WM-BETA58A
Availability: In Stock
Price: $9.90

handheld Dynamic Mic with 20 FT Microphone Cables

Specifications
1.dynamic microphone
2.WM-BETA58A
3.pretty shapes, good quality.best seller
Dynamic OEM  wire microphone 57/58 series
Uni-Direction
Frequency Response: 60Hz-15KHz
Output Impedance: 600ohm±20%
Sensitivity: -76±3dB

Packing
Measure: 48×34.5×30.5cm     1piece/box       20pieces/CTN

* Output Impedance: low impedance inputs with mic connection, rated impedance of 150 ohms (290 ohms actual)
* Phasic: put pressure on the diaphragm, the 2 relative to pin 3 pin for the positive voltage
* Microphone connection: three-pin plugs dedicated audio (XLR-positive plug for maximum conductivity)

·Microphone of use:
 plug in the mcirophone to microphone "MIC"socket. Turn the microphone switch to "ON" position, speak into the microphone, adjust the amplifier's volume control, so that the volume is appropriate. When handing the microphone to others or when not in use, the microphone should be switched to "OFF" position.
 ·Caution:
having the microphone too close to the speaker may produce a loud disturbing sound, because the mcirophones pick up sound from the speakers. This phenomenon is known as a howling Mind. If this happens, pull the mcirophone away from the speaker. As a microphone is a precision component part, be careful not to drop, hit or be given a strong shocl. Should be noted, to put the mcirophone back in the box when not in use, to avoid high and low temperatures, and high humidity.
 ·Good use:
 For best sound effects Fu, the microphone should be placed away from the source (mouth) approximately 5-10cm. Too close to the source, will cause the air to produce a different sound, so that the sound effect will be poor.

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad            Good

Enter the code in the box below:




Powered By OpenCart Your Store © 2011