VHF FM Wireless Microphone with Plastic chassis

VHF FM Wireless Microphone with Plastic chassis

Product Code: VHF110
Availability: In Stock
Price: $23.00

 VHF FM Wireless Microphone with Plastic chassis Inquiry for Lowest Price )

Sample available  just email to us!

System parameter
Carrier frequency:VHF 205-270MHZ
Modulaton mode:FM
Channel number:2channel,
Frequency stability:+/-0.005%
Dynamic range:100dB
Max modulation:+/-75KHZ
Frequency response:30HZ-15KHZ(+/-3dB)
S/N rato:>105dB
THD:  ≤ 0.5%
Working range:50-80M(without obstacle)
Working temperature:-10-40°C

Receiver mode:Heterodyne frequency comversion receiver
Intermediate frequency:10.7MHZ
RF squelch: ≥ 75dB
Max level output1V
Power: DC 12V/300mA

Antenna:Handheld microphone with built-in screw antenna
Output power:30mV
RF squelch:60dB
Power:2*1.5V AA
Battery life:About 10 hours

Receiver operation way
1. Set up the antenna 1&2, pull the antenna 1&2 and make the angle 90 by it and receiver
2. Connect with AC/DC power jack.
3. Audio output connection:
Mix-Unbalance output connection: Plug the end of audio cable jack into the UN BALANCE OUT: 1&2, plug another end into the MIC IN or AUX IN socket into mixer.
4. Open the power and the power indication light will shining.
5. When the switch of microphone on the ON location, the RF signal of receiver will shining; When the receiver output the voice, the volume can control by the knob.

Transmitter operation way:
1. Open battery cover, put 1 × 9V battery, then fasten battery cover.
2. Put the power to “PWR ON” position, the green indicate light is bright when the battery is normal. The red indicate light low-bat is bright, the batter only can use one hour or less. The two light is not bright; the battery has run down or load wrong. Please change or load again.
3. Put the power to middle (STB position), it is mute function.
4. Not use, Please put the switch to off position, please take away the battery when not use for long time. Avoiding to battery liquid leak out and damage the battery and parts.
5. Volume increased button, increase volume adjust so that can suit different machine.
6. When turn on the transmitter, the receiver have not RF, please check the transmitter the frequency with receiver, otherwise reset

Parts detail
Audio connector cable
Built out power adopter
Guarantee card

Write a review

Your Name:

Your Review: Note: HTML is not translated!

Rating: Bad            Good

Enter the code in the box below:

Powered By OpenCart Your Store © 2011