UHF750 Dual Wireless Handheld Microphone System

Product Code: UHF750
Availability: In Stock
Price: $125.00
Qty:  Add to Cart
This product has a minimum quantity of 100

UHF750 Dual Wireless Handheld Microphone System ( Inquiry Latest Price )

System parameter
Receiver   
Frequency rage 590-890MHz 
Max frequency 100*2 
Frequency interval 30MHz*2 
Receiver sensitivity <-97dBm for 30dB S/N ratio 
Frequency response 60-15000Hz 
S/N >105dB(A) 
Dynamic range >100dB 
Audio plug XLR+jack 
Antenna 2 BNC,50Ω 
Audio output level XLR:+8dBu max 
Power supply 12-18V 
Size 410*195*44mm 
Weight 1400g 
    
Transmitter   
Frequency rage 590-890MHz 
Max frequency 100*2 
Output power 5mW/30mW 
Vice wave suppression >70dBc 
Frequency interval 60MHz 
Max modulation +/-48kHz 
Frequency response 60-15000Hz 
Frequency response 60-15000Hz 
S/N >105dB(A) 
Dynamic range >100dB 
Input voltage rage mic 1V max 
Power supply 2*1.5V(AA) 
Size D=50mm,L=264mm 
weight 400g

Receiver operation way
1. Set up the antenna 1&2, pull the antenna 1&2 and make the angle 90 by it and receiver
2. Connect with AC/DC power jack.
3. Audio output connection:
Mix-Unbalance output connection: Plug the end of audio cable jack into the UN BALANCE OUT: 1&2, plug another end into the MIC IN or AUX IN socket into mixer.
4. Open the power and the power indication light will shining.
5. When the switch of microphone on the ON location, the RF signal of receiver will shining; When the receiver output the voice, the volume can control by the knob.

Transmitter operation way:
1. Open battery cover, put 1 × 9V battery, then fasten battery cover.
2. Put the power to “PWR ON” position, the green indicate light is bright when the battery is normal. The red indicate light low-bat is bright, the batter only can use one hour or less. The two light is not bright; the battery has run down or load wrong. Please change or load again.
3. Put the power to middle (STB position), it is mute function.
4. Not use, Please put the switch to off position, please take away the battery when not use for long time. Avoiding to battery liquid leak out and damage the battery and parts.
5. Volume increased button, increase volume adjust so that can suit different machine.
6. When turn on the transmitter, the receiver have not RF, please check the transmitter the frequency with receiver, otherwise reset

Parts detail
Receiver
Transmitter
Audio connector cable
Built out power adopter
Battery
Instruction
Guarantee card

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad            Good

Enter the code in the box below:




Powered By OpenCart Your Store © 2011