UHF5400W 2 channel fixed uhf microphone

Product Code: UHF5400W
Availability: In Stock
Price: $60.00
Qty:  Add to Cart
This product has a minimum quantity of 10

UHF5400W 2 channel fixed uhf microphone ( Inquiry Latest Price )

Specifications
1.best UHF wireless mic 
2.UHF 2 fixed channel,iron material 
3.Anti-jamming circuit 
4.Plastic big receiver 
Carrier Frequency:UHF600~900MHz
Modulation mode: FM
Channel number: 2 Channel
Frequency Stability:±0.005%
Dynamic Range: 100dB
Max modulation: ±75KHZ
Frequency Response: 30Hz-15kHz(±3dB)
S/N Ratio:>105dB
Total Harmonic Distortion (T.H.D.): 0.5%
Working range: About 50~80M(without obstacle)
Working temperature range: -10~40 °C

Receiver
Receiver mode: Heterodyne frequency conversion receive
Intermediate frequency: 10.7MHZ
RF squelch:≥75dB
Max level output: 1v

Power:DC 12V/300mA

Transmitter

Antenna:Hand-hold microphone with built-in screw antenna

Output power:30mW

RF squelch:60dB

Power:DC 2*1.5V AA

Battery life: About 10 hours
System parameter
Receiver operation way
1. Set up the antenna 1&2, pull the antenna 1&2 and make the angle 90 by it and receiver
2. Connect with AC/DC power jack.
3. Audio output connection:
Mix-Unbalance output connection: Plug the end of audio cable jack into the UN BALANCE OUT: 1&2, plug another end into the MIC IN or AUX IN socket into mixer.
4. Open the power and the power indication light will shining.
5. When the switch of microphone on the ON location, the RF signal of receiver will shining; When the receiver output the voice, the volume can control by the knob.

Transmitter operation way:
1. Open battery cover, put 1 × 9V battery, then fasten battery cover.
2. Put the power to “PWR ON” position, the green indicate light is bright when the battery is normal. The red indicate light low-bat is bright, the batter only can use one hour or less. The two light is not bright; the battery has run down or load wrong. Please change or load again.
3. Put the power to middle (STB position), it is mute function.
4. Not use, Please put the switch to off position, please take away the battery when not use for long time. Avoiding to battery liquid leak out and damage the battery and parts.
5. Volume increased button, increase volume adjust so that can suit different machine.
6. When turn on the transmitter, the receiver have not RF, please check the transmitter the frequency with receiver, otherwise reset


Parts detail
Receiver
Transmitter
Audio connector cable
Built out power adopter
Battery
Instruction
Guarantee card

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad            Good

Enter the code in the box below:




Powered By OpenCart Your Store © 2011